Sony Trinitron KV-SA32 - Power

37
Additional Information
Sony KV-SA32M36 Group F12 (GB)_2-348-392-11 (1)
No picture
No sound
Good picture
No sound
Dotted lines or
stripes
Double images or
“ghosts”
No color
Possible causeSymptom Solutions Page
• The power cord,
antenna or VCR is not
connected.
• The TV is not turned
on.
• The volume level is too
low.
• The sound is muted.
• PIP sound is selected
when PIP is displayed.
• There is local
interference from cars,
neon signs, hair dryers,
power generators, etc.
• Broadcast signals are
reflected by nearby
mountains or
buildings.
• The antenna setup is
inappropriate.
•
Use of an external
booster is inappropriate.
• The color level setting
is too low.
• The color system
setting is
inappropriate.
• The antenna setup is
inappropriate.
• Check the power cord, antenna and VCR
connections.
• Press
?/1 (power).
• Press ! (main power) on the TV to turn
off the TV for about five seconds, then
turn it on again.
• Press 2 + to increase the volume level.
• Press to cancel the muting.
• Press
or .
• Do not use a hair dryer or other
equipment near the TV.
• Check the antenna setup. Contact a Sony
dealer for advice.
• Use a highly directional antenna.
• Use the fine tuning (“Fine”) function.
• Check the antenna setup. Contact a Sony
dealer for advice.
• Turn off or disconnect the external booster
if it is in use.
• Display the “Picture” menu and select
“Personal” of “Mode”, then adjust the
“Color” level in “Picture Adjustment”.
• Display the “Setup” menu and check the
“Color System” setting (usually set this to
“Auto”).
• Check the antenna setup. Contact a Sony
dealer for advice.
33
10
9
10
10
16
–
–
–
30
–
–
24
32
–
continue
01GB08ADV-STMOce.p65 10/14/04, 6:08 PM37
Black