Sorensen DLM16-185E - Page 10

Contents Sorensen DLM-E Series
2.5 Location, Mounting, and Ventilation..................................................................14
2.5.1 Unit Dimensions..................................................................................14
2.5.2 Rack Mounting....................................................................................14
2.5.3 Ventilation ...........................................................................................14
2.6 AC Input Power Connection..............................................................................15
2.6.1 AC Input Power Requirements............................................................15
2.6.2 Input Line Impedance .........................................................................15
2.7 Initial Functional Tests ......................................................................................16
2.8 Load Connection...............................................................................................16
2.8.1 Load Conductor Ratings .....................................................................17
2.8.2 Noise and Impedance Effects.............................................................17
2.8.3 Making the Connections .....................................................................18
2.8.4 Connecting Single Loads....................................................................18
2.8.5 Connecting Multiple Loads..................................................................19
SECTION 3 BASIC OPERATION ........................................................ 21
3.1 Introduction .......................................................................................................21
3.2 Standard Operation...........................................................................................21
3.2.1 Operating Modes and Automatic Crossover.......................................21
3.2.2 Local Programming Mode Operation..................................................23
3.3 Using Remote Sensing .....................................................................................24
3.3.1 Connecting Remote Sense Lines .......................................................24
SECTION 4 ADVANCED OPERATION................................................ 27
4.1 Introduction .......................................................................................................27
4.2 Configuring for Remote Programming, Sensing, and Monitoring .........................28
4.2.1 Programming, Monitoring, and Control Functions...............................28
4.2.2 Rear Panel DIP Switch .......................................................................29
4.2.3 Resetting Rear Panel DIP Switch Settings .........................................30
4.2.4 Making J3 Connections.......................................................................30
4.3 Remote Programming of Output Voltage and Current Limit .............................31
4.3.1 Programming Output Voltage and Current Limit with the
REMOTE/LOCAL Switch ....................................................................32
4.3.2 Programming Output Voltage..............................................................33
4.3.3 Programming Output Current Limit .....................................................35
4.3.4 Remote Programming Only the Output Voltage or Current Limit........37
vi Operation Manual