BMK-8 U / BMK-12 W
12
• Check welding cable and connections of the stud welder for damage such as burn-off, mechanical
wear etc. and have damaged parts replaced by the SOYER customer service.
2 General
2.1 The following should be principally observed...
With this stud welder you have purchased a product which
• is state-of-the-art technology
• fully complies with the current safety requirements and
• enables successful working
Before installing the stud welder, please observe the following:
• Store the operating instructions in a place accessible to every operator.
• Ensure that the respective operator has read and understood the operating instructions prior to
installation. Each operator should confirm this per signature.
• Prevent the stud welder being operated by unauthorized personnel.
• Only trained personnel may operate the stud welder.
• Call a doctor in case of an accident.
2.2 Application
The BMK-8 U / BMK-12 W SOYER stud welders for short-cycle drawn arc welding allow SOYER
threaded studs made of plain steel, stainless steel and heat-resistant steel as per DIN EN ISO 13918
to be welded on different workpieces (sheets, tubes, steel girders etc.).
Usually round pins with or without thread are welded. You may also weld fasteners with different
cross-sectional shapes. For this purpose, however, special stud holders and ceramic ferrules or gas
shrouds are required.
With the BMK-8 U / BMK-12 W SOYER stud welders it is also possible to weld studs of other metallic
materials than steel. It is, however, necessary to first carry out experimental welds and to inspect
them.
2.3 Marketing and service
If you have any questions regarding the operation of the BMK-8 U / BMK-12 W stud welders, retrofits
for special applications or if you require service, please contact your responsible service office or the
following address:
Heinz Soyer Bolzenschweißtechnik GmbH
Inninger Straße 14
D-82237 Wörthsee
Telephone +49 8153-885-0 Telefax +49 8153-8030
www.soyer.de info@soyer.de
To Next Page
Loading...
