BMK-8 U / BMK-12 W
4
Congratulations on purchasing a SOYER stud welder. You have made an excellent
choice. Your SOYER stud welder was specially developed for the high-speed
fastening of SOYER welding studs in compliance with DIN EN ISO 13 918 on metallic
workpieces.
Our devices have been tested with regard to safety requirements and corres-
pond to the currently valid European and national guidelines. Proof of
conformity has been established and the manufacturer is in possession of the
corresponding documents.
FOR YOUR SAFETY
Read all of these operating instructions prior to start-up. Please
follow all safety precautions as well as all chapters of these
operating instructions before starting to weld. Non-compliance
with the safety precautions can result in serious personal injuries
or death.
SOYER
®
is a registered trade mark of Heinz Soyer Bolzenschweißtechnik GmbH.
It is prohibited to transmit or reprint this document, as well as to utilize or disclose its
contents, unless this has been expressly granted.
Non-compliance with this regulation is liable to compensation. All rights reserved,
particularly in the case of a patent grant or a GM registration.
We have verified that the contents of this pamphlet correspond to the hard- and
software described. Deviations, however, cannot be excluded so that we cannot
warrant for absolute compliance.
The illustrations contained in this instruction manual may vary in some details from
your product. This, however, has no influence on the handling of the machine.
The data in this documentation have been verified regularly and necessary corrections
will be incorporated in future impressions. Any suggestions for improvement will be
appreciated.
Date of issue: August 01, 2006
Revision
© Heinz Soyer Bolzenschweißtechnik GmbH 2006 · All rights reserved
Printed in the Federal Republic of Germany
To Next Page
Loading...
