91369 Service Manual 2-27
Setup
RTS Threshold (default = 0)
Valid values are in the range of 0 to 2339, inclusive.
Fragmentation Threshold (default = 0)
Valid values are in the range of 256 to 2338, inclusive. The default setting is 0.
Network Configuration Messages
The following messages may occur if a networking entry is misconfigured. The default setting is 0.
Cannot switch Radio ON with invalid region
Monitors display this warning if the value displayed in the Region input cell on the WLAN tab [refer to Region
(default = blank) on page 2-22] is invalid and SAVE is selected.
TTL XX is out of range (either < 1 or > 64)
Where XX is the value entered in the TTL cell on the Monitors tab. (Monitors display this warning when the
TTL input cell loses focus if the entered value is not within the valid range.) If the value entered is nonnumeric,
then the displayed value changes back to the most recently saved numeric value.
WEP KeyY invalid. This key should be 26 HEXADECIMAL characters
(when WEP128 is selected);
-OR-
WEP KeyY invalid. This key should be 10 HEXADECIMAL characters
(when WEP40 is selected).
Monitors display one of these warnings if the value entered in that WEP key’s input cell on the Security tab
contains a nonhexadecimal character and SAVE is selected.
Wireless configuration out or range error messages
Monitors display one of the following warning messages if that input cell’s value for the WLAN is out of range,
and SAVE is selected. XXXXX represents the entered value.
Wireless Fragmentation Threshold XXXXX is out of range (either <256 or > 2338) (Advanced tab).
Wireless RTS threshold XXXXX is out of range (either <0 or >2339) (Advanced tab).
Wireless outbound parameters XXXXX is out of range (either <0 or > 6) (WLAN tab).
Invalid Region Code — XXX (either <0 or > 99) (WLAN tab).
Note:
If the invalid IP address or subnet mask is related to use of the WLAN, monitors that are configured for
radio/WLAN operation append “WLAN” to the start of the error messages describe below.
To Next Page
Loading...