User manual EXPERT 2K-FA
Pag. 39 of 39 Issue 2 – May 2011
In the following picture can be seen, as an example, the Power Control setting relative
to the same band (20 m), but using the LOW mode selection instead.
Once the correct preset is adjusted, go to TX mode (RTTY, CW) to verify the output
power.
ATTENTION! It is strongly recommended to start with a low preset value (e.g. 10) and
progressively increase it; this is to avoid the linear overdriving.
The following empty table could be useful as a template for the FlexRadio user’s Power
Control pre-settings.
Band 160 m 80 m 40 m 30 m 20 m 17 m 15 m 12 m 10 m 6 m
MAX
MID
LOW
12.7 TRANSCEIVERS OF OTHER BRANDS
A special link is not necessary as the internal amplifier frequency counter will measure
the input frequency and will control the amplifier.
Note: WARNING, SPE is not responsible for any failure resulting from misuse of HW
interface.
To Next Page
Loading...
