39
4-3. Setup – Record Mode
In the SETUP menu, select the Record tab. Then, the Record menu is displayed as pictured below.
Navigate through the menu items or change the settings using the mouse or the remote control.
Figure 4.3.1. Record Setup Screen
Table 4.3.1. Menu Items in Record Setup Screen
Menu Item Description
Site Select a channel for applying the following settings using the mouse or the remote
control. To change the values of all channels, take the following steps. Select the
button “select” to change the values of all channels.
Recording
Mode
Assign the recording mode for the selected channel.
Options are: Continuous, Motion, Schedule or Disable.
Sensor
Recording
Select the sensor setting for the selected channel.
Pre Record Enable/disable pre-event recording. Pre-event recording time is up to 20 minutes.
Post Event
Record
Set the post event recording time duration for the specified channel.
(10~30 seconds)
Audio Enable/disable audio recording for the specified channel.
Schedule Set the recording schedule.
To Next Page
Loading...
