30
R
EFERENCE
& I
NSTALLATION
M
ANUAL
7.4 KEYPAD PANIC OPTIONS
Section [128] - General Options
Option [1] OFF = Emergency Panic Disabled (default)
Option [1] ON = Emergency Panic Enabled
Pressing the [1] & [3] keys simultaneously on the keypad for 2 seconds will generate a silent or audible alarm as
defined by option [4].
Option [2] OFF = Auxiliary Panic Disabled (default)
Option [2] ON = Auxiliary Panic Enabled
Pressing the [4] & [6] keys simultaneously on the keypad for 2 seconds will generate a silent or audible alarm as
defined by option [5].
Option [3] OFF = Fire Panic Disabled (default)
Option [3] ON = Fire Panic Enabled
Pressing the [7] & [9] keys simultaneously on the keypad for 2 seconds will generate a silent or audible alarm as
defined by option [6].
Option [4] OFF = Emergency Panic is Silent (default)
Option [4] ON = Emergency Panic is Audible
Option [5] OFF = Auxiliary Panic is Silent (default)
Option [5] ON = Auxiliary Panic is Audible
Option [6] OFF = Fire Panic is Silent (default)
Option [6] ON = Fire Panic is Pulsed
Silent operation:
The control panel emits a confirmation beep and transmits the appropriate Panic report code if programmed in
section [195]. The control panel will not enable the keypad buzzers or the control panel’s
BELL
output (no audible
alarm).
Audible operation:
Same as silent operation, except the keypad buzzers and the
BELL
output will activate until a user cancels the alarm
(disarms) with a valid User Access Code or when the Bell Cut-Off Timer elapses (see page 29).
Fire (pulsed) operation:
Same as audible operation, except that the
BELL
output will be pulsed as shown in Figure 5-2 on page 22.
Whether the system is partitioned or not, the control panel will report all panic alarms to partition 1.
To Next Page
Loading...
