56
R
EFERENCE
& I
NSTALLATION
M
ANUAL
15.5 REGULAR ARMING
This method, commonly used for day-to-day arming, will arm all the zones in the selected partition. If you make a
mistake, the keypad will emit a "
REJECTION
BEEP
". When you have correctly armed the system, the appropriate "
ARM
"
indication will turn on and the Exit Delay will be initiated. Please note that Regular Arming can also be activated
using Auto-Arming, a Keyswitch or using One-Touch Arming.
15.6 STAY ARMING
This method allows users to remain in the protected area while partially arming the system. For example, when
going to sleep at night, entry/exit points like doors and windows can be armed while other zones like motion
detectors remain deactivated. Please note that Fire Zones can not be bypassed.
If you make a mistake, the keypad will emit a "
REJECTION
BEEP
". When you have correctly Stay Armed the system,
the appropriate “
ARM
”
or “
STAY
”
indication will appear and the Exit Delay will be initiated. Stay Arming can also be
activated using Auto-Arming, Keyswitch Arming or using One-Touch Arming. Also note that the User Code must
have the Stay Arming Option enabled.
15.7 INSTANT ARMING
After Stay Arming the system and during its Exit Delay, press and hold the
[STAY]
button for 3 seconds. You
should hear a "
CONFIRMATION
BEEP
". This will switch all armed zones to Instant zones.
If you have access to both partitions:
To Instant Arm one partition, press [
STAY
] + [
ACCESS
CODE
] + [
SELECT
PARTITION
] + [
CLEAR
] + press & hold [
STAY
]
To Instant Arm both partitions, press [
STAY
] + [
ACCESS
CODE
] + [1] + [2] + press & hold [
STAY
]
How Do I Disarm the System or Deactivate an Alarm?
1) Key in your
[ACCESS CODE]
The arm or alarm indication will turn off and the keypad will emit a
“
CONFIRMATION
BEEP
”.
IF YOU HAVE ACCESS TO BOTH PARTITIONS:
2) Press the button corresponding to the partition you wish to Disarm or
to Disarm both partitions, press the [1] key then after the confirmation
beep press the [2] key.
How Do I Regular Arm?
1) Green “
READY
” indicator must be illuminated. Unless the system is
partitioned, in which case all zones in the desired partition must be closed.
2) Key in a valid [
ACCESS
CODE
]
IF YOU HAVE ACCESS TO BOTH PARTITIONS:
3) Press the button corresponding to the partition you wish to Arm. To
Arm both partitions, press the [1] key then after the confirmation beep
press the [2] key.
How Do I Stay Arm?
1) All zones in the desired partition (except Stay Zones) must be closed.
2) Press the [
STAY
] button
3) Key in a valid [
ACCESS
CODE
]
IF YOU HAVE ACCESS TO BOTH PARTITIONS:
4) Press the button corresponding to the partition you wish to Stay Arm.
To Stay Arm both partitions, press the [1] key then after the
confirmation beep press the [2] key.
To Next Page
Loading...
