SPECTRA SERIES 59
15.15 PROGRAMMING CHIME ZONES
This feature allows users to program which zones will be "Chime Enabled". A "Chime Enabled" zone will cause the keypad
to emit a rapid intermittent beep tone (
BEEP
-
BEEP
-
BEEP
-
BEEP
) advising the user every time it is opened. Each keypad must
be Chime Programmed separately. Keypad chimes must be re-programmed if the system suffers a total power loss.
10-Zone LED Keypad:
Press and hold any button from
[1]
to
[10]
for 3 seconds to activate or deactivate Chiming for zones 1 to 10. For
example, press and hold the [1] button to enable chiming on zone 1. If after pressing and holding a button, the keypad
emits a confirmation beep, this means the chime feature has been enabled for that zone. If the keypad emits a rejection
beep, this means the chime feature has been disabled for the corresponding zone.
16-Zone LED Keypad:
Press and hold the [9] button. Enter the 2-digit (01 to 16) zone number(s). When the corresponding LED is on, the
zone is chimed. When the corresponding LED is off, the zone is unchimed. When the desired zones are chimed,
press [
ENTER
].
LCD Keypad:
Press and hold the [9] button. Enter the 2-digit (01 to 16) zone number(s), or use the arrow keys to scroll through
the zones. and when the appropriate zone is displayed, press the [
FNC
1] button. When the desired zones are
chimed, press [
ENTER
].
15.16 KEYPAD MUTING
Press and hold the
[CLEAR]
button for 3 seconds to enable or disable keypad muting. When muted, the keypad will
only “beep” when a button is pressed or when the keypad emits a rejection or confirmation beep. All other “beep”
functions are disabled.
To Next Page
Loading...
