Spectra 1725 - Partitioning; Programming Access Codes; Disarming & Deactivating an Alarm

SPECTRA SERIES 55
15.2 PARTITIONING
The Spectra system is equipped with a partitioning feature which can divide the alarm system into two distinct areas
identified as Partition 1 and Partition 2. Partitioning can be used in installations where shared security systems are
more practical, such as a home office or warehouse building. If the system is not partitioned, all User Codes and
features will be recognized as belonging to partition 1. Zones manually assigned to partition 2 will no longer
function.
15.3 PROGRAMMING ACCESS CODES
Access Codes are personal identification numbers that allow you to enter certain programming modes, arm or
disarm your system as well as activate or deactivate PGMs. The Spectra security system supports the following:
System Master Code can arm or disarm any partition using any arming method and can create, modify or delete any
User Access Code. Only the System Master Code can modify or delete User Access Codes assigned to both partitions.
Master Code 1 is permanently assigned to partition 1 and can be used to create, modify or delete User Access
Codes that are assigned to partition 1.
Master Code 2 is permanently assigned to partition 2 (except when partitioning is disabled, Master Code 2 will be assigned
to partition 1) and can be used to create, modify or delete User Access Codes that are assigned to the same partition.
45 User Access Codes (including 1 Duress code)
15.4 DISARMING & DEACTIVATING AN ALARM
To disarm an already armed system or to deactivate an alarm simply key in a valid access code. Program a
designated entry/exit point, such as the front door or the garage door with an Entry Delay Timer. When these entry/
exit point are opened (breached), it will set off a timer. The system will not generate an alarm until this timer elapses,
giving users enough time to enter the premises and disarm the system. Any user can disarm the system, except
users have been assigned the Arm Only Option.
How Do I Program Access Codes?
1) Press [
ENTER
]
2) Key in the [
SYSTEM MASTER CODE
] or [
MASTER CODE
]
3) Key in 3-digit
[SECTION]
(see Tab le below)
4) Key in new 4 or 6-digit
[ACCESS CODE]
[
ENTER
] flashes. Return to step 3
How Do I Delete Access Codes?
1) Repeat steps 1 to 3 (see above)
2) Press the
[FORCE]
button once for each digit in the access code (4 or
6 times) until the keypad emits a "
CONFIRMATION BEEP
"
Section User Codes
[001] User Code 001 = System Master Code
[002] User Code 002 = Master Code 1
[003] User Code 003 = Master Code 2
[004] to [047] User Code 004 to User Code 047
[048] User Code 048 or Duress Code
How does a partitioned system work?
• Users can only arm/disarm partitions to which they have been assigned.
• Only zones assigned to Partition 1 will arm/disarm when Partition 1 is armed or disarmed.
• Only zones assigned to Partition 2 will arm/disarm when Partition 2 is armed or disarmed.
• Some of the system’s features can be programmed separately for each partition.