T200, T380, or T680 Transporter Replacement Access the Transporter
August 2012 Replacing the Transporter—Spectra T200, T380, and T680 Libraries
13
3. Prepare to remove the bottom three or four chamber shelves, to provide
comfortable access to the transporter from the front of the library.
Note: For the T200 and T380, removing all of the shelves below the
TAP provides the best access to the transporter.
a. Remove any magazines that are stored in the chambers on the
shelves you plan to remove to provide access to the transporter.
Place covers on the magazines to protect the cartridges during the
replacement procedure.
b. Use a #2 Phillips screwdriver to loosen, but not remove, the two
screws securing the shelf retaining bar to the chassis.
Notes: The screw on the right-hand side of the retaining bar is
accessed through the circular cutout in the chassis.
The shelves behind the fan assembly do not have retaining
bars.
c. Press the shelf retaining bar up and out, so that bar’s keyhole slots
slide off of the two mounting screws. Set the retaining bar aside.
Do not remove or reposition the cartridges in the magazines.
Figure 10 Remove the shelf retaining bar.
To Next Page
Loading...
