Spectra T200 - Page 14

T200, T380, or T680 Transporter Replacement Access the Transporter
August 2012 Replacing the Transporter—Spectra T200, T380, and T680 Libraries
14
4. Remove the shelves.
a. Slide the far left and far right media guides forward and toward the
center of the shelf to release them. Lift the guides off the shelf.
b. Grasp the front edge of the shelf with both hands and pull it toward
you to disengage it from the slots in the front of the chassis and the
rear mounting tabs. Angle the left side of the shelf slightly upward
and slide it out of the chassis. Set the shelf aside.
c. Repeat Step a and Step b, to remove as many shelves as necessary to
provide sufficient access to the interior of the library.
Note: Although not shown in Figure 12, a metal cover protects the
printed circuit board and cables mounted at the front of the
library.
d. Continue with Remove the Transporter on page 17.
Figure 11 Remove the outer media
guides from each shelf.
Important
Make sure that you do not lose any of the media guides.
Figure 12 Remove shelves from the front of the library to provide access to
the transporter (viewed from front of library).
Transporter
Cartridge picking
mechanism
Printed circuit
board