T200, T380, or T680 Transporter Replacement Remove the Transporter
August 2012 Replacing the Transporter—Spectra T200, T380, and T680 Libraries
18
c. Gently rotate the cartridge picking mechanism clockwise 90° so that it
is in a vertical position.
3. Locate the ribbon cable connected to the printed circuit board mounted
on the back of the transporter carriage (see Figure 15).
4. Reach around the back of the cable and pinch inward on the ribbon
cable release tab, then pull gently upward on the connector to
disconnect the cable from the printed circuit board.
Note: If you are working from the front of the library, it is easiest to
reach over the top of the cartridge picking mechanism.
Figure 15 Rotate the cartridge picking mechanism to vertical.
Do not pull the cable out of the connector without releasing the locking tab. Pinch
inward on the locking tab to release the cable so that it can be disconnected from
the printed circuit board.
Figure 16 Disconnect the ribbon cable from the printed circuit board on the back of the transporter.
Back edge of transporter carriage
Ribbon cable and
connector (viewed from
back of transporter)
Pinch inward on the
connector release tab
Printed circuit board
edge connector
To Next Page
Loading...
