Spectra T50e - About This Guide

18
LCM Replacement Instructions 90970024
4. Power on the library via the front panel (see Figure 2).
a. Press and hold the front panel power button for two to three
seconds until the button’s LED illuminates.
b. Wait while the library completes its power-on sequence, which
takes six to nine minutes, depending on the library configuration.
5. Copy the hardware ID—The hardware ID is stored in both the
Transporter and the LCM if your library is running BlueScale 10.3.1 or
later. Once you replace the LCM, the user interface prompts you with
this screen:
Select Controller (LCM). This action prompts the library to copy the
hardware ID to the newly installed component.
The BlueScale user interface is again available through the front panel. You
need to set up your Networking configuration to access BlueScale through
a web browser.
It may be necessary to upgrade firmware on the LCM. See the Spectra T50e
Library User Guide for detailed information about performing firmware
upgrades. The LCM must reboot after a firmware upgrade, which will
interrupt backups.
6. Package the old LCM and ship it to Spectra Logic as described in
Return a Malfunctioning Component on page 22.
It seems that you have replaced either the LCM or
the Robot. Please select the component you
replaced so the configuration can be updated.
RoboticsController
Caution
Selecting the wrong option at the prompt— in this case, selecting Robotics rather
than Controller— results in all of your option keys being lost. Ensure that you
select the correct option.