5
Replacing the Library Control Module
These instructions describe how to replace the T50e Library Control
Module (LCM).
The library contains a single LCM, which provides the logic and circuitry
to control the robotics and display the user interface on the library’s touch
screen. The LCM includes an embedded web server to provide remote
access to the user interface through the Remote Library Controller (RLC)
using a standard web browser. It also houses the flash card. Figure 1 shows
the available connections on the LCM.
Note: Depending on the ASM service level you purchased, the LCM
may not be included in your on-site LCM kit.
BEFORE YOU BEGIN
Ensure that the work area is free from conditions that could cause
electrostatic discharge (ESD). Discharge static electricity from your
body by touching a known grounded surface, such as a computer’s
metal chassis.
Ensure that you have saved a backup copy of your library’s
configuration—see Preparing for Replacement on page 6).
Figure 1 Connections to the LCM.
Ethernet connector
USB ports
Flash (SD) card
LCM
(location and
orientation)
To Next Page
Loading...
