January 2009
Spectra T50e Library
19
RESTORE THE LIBRARY CONFIGURATION
After the library restarts, restore the partition definitions and library
configuration settings using one of the following methods.
Via USB—Restore the configuration you previously saved to a USB
storage device or uploaded to a file on a computer.
Note: If you were unable to save the configuration to a USB,
reconfigure the library using the information that you wrote
down in You do not have a Valid Backup Library Configuration
on page 6.
Via Flash Card—If SpectraGuard Support directs you to do so, remove
the card from the LCM you replaced and install it in the new LCM flash
card slot (see Figure 1).
Via the Remote Library Controller (RLC)—Re-enter the partition
configurations and other library configuration settings as described
below.
Restoring the Configuration via USB
This utility restores the library configuration from a USB device. The
restore choices available are the previously stored configurations. This
utility resets the library when completed.
1. Insert the USB device with the saved configuration into one of the USB
ports in the back of the library (see Figure 1).
2. Select Maintenance > Utilities > Tools > Advanced > Next.
3. Select the Restore Configuration from USB and RUN this test. The library
power-cycles after this utility completes.
If you do not have a saved configuration on the USB device, but have one
saved in email or on your local system, you must set up networking and
then access the library via the RLC to restore the configuration saved in
email or on your local system.
Restoring the Configuration via the RLC
1. Log into the library front panel with superuser or administrator
privileges.
2. Determine your network address requirements (Static or Dynamic).
Dynamic IP addressing is the default setting.
To change the address to static, select Menu > Configuration >
Network. Set the static address.
To Next Page
Loading...
