20
LCM Replacement Instructions
90970024
3. Select Maintenance > Utilities > Show Advanced > Yes.The Utilities
screen refreshes to show the advanced utilities.
4. Scroll through the options and select the one that is most suitable for
your situation:
Option Use this option to...
Restore
Configuration from
Checkpoint
Restore the library configuration from the checkpoint made at the last package
upgrade. This should only be run after a package downgrade. This utility resets
the library when completed.
Upload Backup
Configuration
a
a. These options are only available when you access the library from a web browser using the RLC.
Upload a configuration file that you previously saved on a computer to a
temporary location in the library memory.
Note: If you used this option, you must then run the Restore Library
Configuration from Uploaded File utility to restore the library configuration.
Restore Library
Configuration from
Uploaded File
a b
b. Please note that this option may not be possible until you configure your library network settings.
Complete the restore process started by Upload Backup Configuration by
uploading a a saved configuration file from a computer using the RLC. This
utility resets the library when completed.
Note: This option is used in conjunction with Upload Backup Configuration,
which must be completed first.
Restore Library to
Backup
Configuration
Reset the library to the backup configuration stored on the RCM. The RCM will
store a backup configuration when either the Reset to Factory Defaults or
Remove All Library Partition diagnostics are run. This utility resets the library
when completed.
Press this button
to begin the upload
process.
To Next Page
Loading...
