SpectraLink S33 - Turning Handset On;Off

Spectralink S33 Handset User Guide
Handset S33 User Guide.docx
July 2023 15
Your wireless handset may occasionally need to be cleaned. Generally, wiping the handset’s
surface with a water-dampened cloth or lightly moist paper towel will remove most films or
residues. Commercial off-the-shelf solutions like Lysol® Disinfecting Wipes (or similar),
which clearly shows in the ingredients list that it is “bleach-free” may also be used.
If the soiling is too stubborn for plain water, a mild liquid detergent solution may be mixed
with water and used. However, be sure to always wipe away any residue with a plain water-
dampened cloth.
It is important to note, that it is not allowed to spray directly on the handset. You should only
occasionally clean the handset and always use a damp cloth or paper towel.
Turning Handset On/Off
For more information about the handset keys and display, see “Handset Keys”, on page 16
and “Handset Display” on page 20.
To Turn Handset On
• Press to turn on handset.
To Turn Handset Off
• Press until the question “Turn off?” appears on the display.
• Press to confirm.
Accessories
The handset can be fitted with a holster and two types of belt clips: a stationary clip, and a
swivel clip. The accessories are purchased separately. In order to install the belt clips:
1. Remove the label strip found on the back of the handset.
2. Remove the two screws holding the backplate.
3. Lift off the backplate.
4. With the backplate removed, place the belt clip in its place.
5. Tighten the screws until the belt clip is firmly seated.
Note:
The handset will not fit into the holster with a belt clip attached.