Using GMOS 10
USING GMOS
Charging GMOS
For safety purposes, the battery that comes with your GMOS has just enough
charge to sustain a working voltage. Please charge the battery before starting using
your GMOS.
To charge the battery, please use the supplied USB cable to connect your GMOS
with a computer, an external battery pack charger, or an AC-USB converter plug,
and then insert the plug to a wall outlet.
Once the charging starts, you will see a red light blink on on the top right corner.
Please make sure both the power and the backlight are off during charging; other-
wise, the battery will never be full. The red light will go off once the the charging is
complete. Normally, this will take about 2.5 hours.
If you are going to put GMOS away for a couple of months or more, DO NOT store
it on an empty battery. Keep it in an environment near 20˚C (68˚F). Otherwise, the
battery life might be reduced severely.
Getting Started
When GMOS is powered on, you will see the Welcome Screen
appear, displaying your User ID (can be edited via SpeedAngle
R3), GMOS model, and its registration number for 5 seconds.
You can press any key to skip the wait.
Then GMOS will display the Liability Screen. Please read it
carefully. Then GMOS will enter Drive mode or Timer Mode
automatically, depending on which Mode you were in when you
turned GMOS off last time. Please note that data are not shared
between modes.
In Drive mode, GMOS displays your speeds, lean angles, and G’s, and record these
data plus GPS traces. In Timer Mode, GMOS displays the speeds, G’s, and lap
times, and records these data plus lean angles and GPS traces.
3
PLEASE CHOOSE SAFETY
OVER PERFORMANCE WHEN
RIDING. BY USING THIS
DEVICE, YOU AGREE TO
ASSUME ALL RISK AND
RESPONSIBILITY
RELATED TO ITS USAGE.
To Next Page
Loading...
