SpeedAngle GMOS JI100S - Configuring the Timer

Using GMOS 23
Go back to your Start location. Enter Laptimer Menu, make sure “
SET FL AT
TRACK15”
is off, and then select the Track you have just set (Track 15). Exit Menu.
GMOS will prompt the Track you designated in Standby Screen. Now you are ready
to go. GMOS will start the Timer when you reach the starting speed, and produce
lap times when you ride past the Finish Line location.
Conguring the Timer
In the Laptimer Menu, you can:
• view the Lap Time Report of up to 14 latest logs,
• activate Auto Set to set a new Track at Track 15 later,
• designate a Track to use later,
• designate the Timer starting speed,
• designate at what idle time the Timer is to stop,
• designate the length of the Finish Line,
• designate what is to be displayed as Main Display or Sub Display, and
• designate how long the Main Display and Sub Display are to be held after updated.
In the Laptimer Menu, pressing SELECT will execute the function selected or adjust
the value. Pressing MENU will go to the next item. Below we will show you how to
congure the settings: