Using GMOS 21
To see the time, top speed, and average speed of each lap,
press
SELECT
to enter DETAIL. To exit DETAIL, either press
MENU
to go to EXIT and press
SELECT
to conrm, or do nothing.
Once you reach the starting speed again, GMOS will automati-
cally exit and start the Timer.
• If there were less than 3 full laps created, there will be no
summary available. You will see “
NOT ENOUGH DATA” instead.
• If no Finish Line was crossed at all, There will be no report
available. GMOS will go back to Standby Screen directly.
• To view the reports of up to the previous 14 logs, please enter
LapTimer Menu and go to
“
VIEW LATEST RECORDS”.
Advanced: Setting a Better Finish Line with Auto Set
How A Finish Line Is Set with Auto Set
When GMOS is setting a new Track with Auto Set, it
marks the location where the staring speed is reached
as a reference point, uses the following 10 meter trace
as a direction pointer, and draws a line extending 50M
from the reference point to both sides perpendicular to
your trace. This is your Finish Line. Then GMOS also
marks your riding direction as the valid crossing direc-
tion of this Line. This is to prevent unwanted Lap times
when the Line is crossed from a wrong direction. Then
GMOS will go on to start the Timer.
How to Control Your Finish Line Location
As the location where the Finish Line is set depends on where the starting speed
is reached, you can control the location of the Finish Line by designating a proper
starting speed. Here are a few suggestions:
Desired FL location Suggested Starting Speed
Right close to where you are 10
On a straight 150 or more
The key is to keep your speed below the designated starting speed until you reach
your desired Finish Line location.
10 M
Valid Crossing
Direction
Finish Line
Track Border
50 M
50 M
To Next Page
Loading...