Installing GMOS 5
INSTALLING GMOS
The installation of the GMOS dashboard unit and sensor unit is easy. No drilling
or wiring is required. After the installation, please remember to align the sensor as
instructed, and then you are ready to go.
Installing Dashboard Unit
Location
Please install the dashboard at the front beyond the steering stem area and keep it
clearly visible to the sky.
Best
Might be obstructed from the sky
Installation
To install the dashboard, please install the bracket first. You can either use the
supplied 3M Dual Lock tape and adhere the bracket to a place you like, or buy an
AMPS hole pattern mount from the market and bolt the bracket to the mount.
With 3M Dual Lock Tape
To use , clean the mounting surface and the back of the brack-
et with alcohol and wipe dry. Keep the SA logo rightside up.
Apply the joined pieces to the back of the bracket and press
the bracket to the mounting surface. Let sit for at least 24 hours
after the application to obtain the best bonding strength.
With AMPS pattern Mount
If you are using an AMPS hole pattern mount (many mounts available in the market
t in this category), please nd the diagonal holes on the bracket and t them with
2
Bracket Back
To Next Page
Loading...
