12
SPEKTRUM DX10t • RADIO INSTRUCTION MANUAL
EN
7. BASIC PARAMETER PROGRAMMING IN THE FUNCTION MENU OF A
WING-TYPE MODEL WITH 5 CHANNELS
6-21 Transfer SD Card
With this menu you can transfer model memories onto
an SD Card and create model memory space in the
transmitter. The included 1GB card has the capacity to
store up to 3000 Models.
Options in the menu are:
• Import Model : One selected Modell will be transferred
from card.
• Import all Models: All models will be transferred from
card.
• Export Model: One selected model will be exported to
card
• Export all Models : All models will be exported to card.
• Update Firmware
Attention: If you activate more channels in the System
Settings, you have to program them in the Function
menu.
After powering the radio on, the model type displays in
the Startup screen. If your model is an Airplane, you have
to program the parameter of the function list at this point.
Parameters are:
• Servo Setup
• D/R and Expo
• Throttle Cut
• Throttle Curve
• Mixing
• Range Test
• Timer
• Telemetry
• Monitor
7-1 Servo Setup
In this menu, you program all settings for servo
parameters.
Parameters are:
• Travel
• Sub-Trim
• Reverse
• Speed
• Absolute Travel
• Balance
7-1-1 Travel
In this menu, you program travel for all 10 channels.
Default channels are: Throttle (THR), Aileron (AIL),
Elevator (ELEV), Rudder (RUD) Gear (GER).
The Display shows travel in percentage and graphics.
7-1-2 Sub-Trim
You can adjust Sub-Trim settings with the Roller.
Default channels are: Throttle (THR), Aileron (AIL),
Elevator (ELEV), Rudder (RUD) Gear (GER).
If other channels are active, you will see them in the 5
free AX1 – 5 channels below.
7-1-3 Reverse
Programming of Servo Reverse function will be done in
this menu. Reverse Information is shown in the graphic.