Spektrum DX10t - Channel Assignment

16
SPEKTRUM DX10t • RADIO INSTRUCTION MANUAL
EN
8-6 Channel Assignment
This menu is for assigning functions to channels. The
Display shows 6 servos you can assign.
Channel 1 Throttle
Channel 2 Aileron
Channel 3 Elevator
Channel 4 Rudder
Channel 5 Gyro
Channel 6 Pitch
Channels 7 – 10 are not assigned.
8-7 Trim Setup
In this Menu, you can adjust trim sensitivity. The mean
value is 5 Largest steps with 10, no steps with 0.
8-8 Model Copy
Please refer to wing-type model programming for
instructions.
8-10 Warnings
In this screen, you select warnings and assign them to
functions that will be active when values are exceeded.
8-11 Telemetry
Please refer to wing-type model programming for
instructions.
8-9 Model reset
Please refer to wing-type model programming for
instructions.
8-12 Preflight Check
The list contains parameters for wing and helicopter type.
Similar to the wing-type model, there are 6 lists with 6
parameters with specific helicopter settings.
8-13 Frame Rate
Please refer to wing-type model programming for
instructions.
8-14 Bind
Please refer to wing-type model programming for
instructions.
8-15 Trainer
This configuration shows you what functions are
controlled by Master or Slave. Functions are free to
assign.