EasyManuals Logo

Spektrum DX7 User Manual

Spektrum DX7
115 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #100 background imageLoading...
Page #100 background image
N, tai Normaali asentoa tulisi käyttää moottorin käynnistyksessä ja leijutuksessa. Asentoja 1 ja 2, tai
Stunt 1 ja Stunt 2 tulisi käyttää taitolentoliikkeissä ja taivaslennossa.
Huom. Kaasun trimmi ja leijutuksen kaasun asento ovat käytettävissä vain kun lentotilakytkin on
Normaali asennossa. Siten Stunt 1 ja Stunt 2 asennoissa näillä kahdella toiminnalla ei ole vaikutusta.
Jokainen kaasukäyrän viidestä (5) pisteestä on erikseen säädettävissä alueella 0 – 100 %. Nämä viisi (5)
käyrän pistettä vastaavat tikun asentoa kyseisessä kohdassa.
Lähettimeen on tehtaalla esisäädetty suora, eli lineaarinen kaasukäyrä, kuten alla olevasta kuvasta
näkyy. Jokainen viidestä eri käyrän pisteestä voidaan erikseen aktivoida ja sen tasoa voidaan vähentää /
kasvattaa sopimaan käyttäjän erityistarpeita vasten.
Press to enter
THROTTLE CURVE Press to change values
Paina päästäksesi
KAASUKÄYRÄÄN Paina muuttaaksesi arvoja
Press to enter Press to select Press to return
Function Mode desired points value to default
Paina mennäksesi Paina valitaksesi Paina palauttaaksesi
Toimintatilaan haluamasi pisteet arvo tehdasasetuksille
To Access the Throttle Curve Function
Press the DOWN and SELECT keys simultaneously to access the System Mode.
In System Mode, use the UP or DOWN keys to select the THRO CURVE NORM screen.
Press the SELECT button to access pitch points L (Low), 1, 2, 3, or H (High) or EXPO.
Press the INCREASE or DECREASE keys to change the selected pitch value or expo on/off.
Päästäksesi Kaasukäyrä toimintoon
Paina DOWN ja SELECT kytkimiä samanaikaisesti päästäksesi Järjestelmä tilaan.
Järjestelmä tilassa, käytä UP tai DOWN kytkimiä valitaksesi THRO CURVE NORM näyttö.
Paina SELECT kytkintä päästäksesi käyrän kulmapisteille L (Alin) 1, 2, 3 tai H (Ylin), tai EXPO.
Paina INCREASE tai DECREASE kytkintä muuttaaksesi valitun kulmapisteen arvoa tai EXPO päälle/Pois.
Sivu 88
Throttle Trim Setting
The throttle trim lever is only active when the flight mode switch is in the normal position. The throttle trim is
used to increase or decrease the engine rpm to achieve a reliable idle when in the Normal Mode. The throttle
trim lever has no effect in flight modes 1 or 2 (Stunt 1 or Stunt 2), or throttle hold.
Kaasun trimmin asetukset
Kaasun trimmi asetus on aktiivinen ainoastaan, kun lentotilakytkin on Normaali asennossa. Kaasun
trimmiä käytetään vähentämään tai lisäämään moottorin tyhjäkäyntikierroslukua, jotta se olisi sopivalla
tasolla Normaali lentotilassa. Kaasun trimmi tasolla ei ole vaikutusta Stunt 1 tai Stunt 2 eikä Kaasun
pudotus asennossa.
Hovering Throttle Rocker Setting
The hovering throttle rocker increases or decreases the engine throttle position for the center point only (point
#2) of the throttle curve. Use of the hovering throttle rocker shifts the middle curve upward or downward.
Therefore, operation of the hovering throttle rocker does not cause any change to the high point and low point of

Table of Contents

Other manuals for Spektrum DX7

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Spektrum DX7 and is the answer not in the manual?

Spektrum DX7 Specifications

General IconGeneral
InterfaceRF Wireless
Product colorBlack
Remote control proper use-
Built-in displayYes
Maximum range- m
Frequency band2.4 GHz
Channels quantity7 channels
Number of devices supported250
Battery capacity2000 mAh
Quantity per pack1 pc(s)
Weight and Dimensions IconWeight and Dimensions
Weight- g

Related product manuals