06/02/2020 Vers. 0.0 50
Use the arrow “right/left” keys to navigate through the menu and select the option “Manual/Automatic”;
Confirm the option by pressing the “Enter” key.
If the station is preset for Standard and Hybrid systems, the display will show the choice of the type of system
Standard / Hybrid.
Select with the “up/down” keys the system type desired and confirm by pressing “Enter” key.
Internal cleaning according to the type of system selected
Take Notice: if it is selected another type of system, different from the previous one completed, it will be executed
an internal cleaning.
WARNING! Before selecting the system type ensure that the two quick fittings of high and low pressure located at
the end of the hoses are connected to the two male connectors situated on the station (img 6-g)
DO NOT EVER RUN AN INTERNAL CLEANING WITH THE FITTINGS CONNECTED TO THE VEHICLE
WAIT until the end of the cleaning to proceed. The cleaning operation will end when the display shows a message
after the oil drain.
WARNING! If the cleaning cycle is interrupted it will be required to initiate the cleaning every time, even selecting
the same system type.
Manual cycle operating stage
In the menu, select the type of operation among those listed:
− Recovery (R)
− Vacuum (V)
− Vacuum Test (T)
− Oil Injection (Smix - Hmix)
(standard or hybrid according to the system type)
− Gas Charging (C)
Use the arrow “right/left” keys to navigate through the menu and select the
different stages.
Use the arrow “up/down” keys to change the information of the selected stage.
Press the “Enter” key to start the procedure.
Take notice : to the oil injection (standard or hybrid) or the gas charging, the system has to be vacuumed (run a
vacuum procedure before using it).
To Next Page
Loading...