5
o HV Probe Duckbills Testing a form 3, 4, 5, 6, 8, or 9 meter
circuit (high or low voltage CTs)
When you turn on the 6000 Bird Dog Plus, after the logo screen appears, you will see a
screen that says, “Following Switch Positions Detected.” Make sure that these switch
selections correspond to the test you plan to perform. If not, turn the unit off, change the
switch positions, and turn the 6000 Bird Dog Plus back on.
Auxiliary—Future Use
P2--Connector going to the P2 port of the Bird Dog Plus
P3--Connector going to the P3 port of the Bird Dog Plus
Note—Previous Owners of the 1500 High Voltage Kit: If you are upgrading your 5000
Bird Dog Plus to a 6000 Bird Dog Plus and you previously owned a 1500 High Voltage
Kit, the circuit board that was in your Retriever Interface Box has now been incorporated
into the 3 Phase Connector Box, making your connection to the 6000 Bird Dog Plus much
easier. Simply connect the fiber optic cable to the 3 Phase Connector Box and connect the
other end of the fiber optic cable to the probe head.
Now you are ready to begin connecting your probes to the site and start testing with your 6000
Bird Dog Plus.
To Next Page
Loading...