1
SECTION F.1
SETUP PROCEDURE
FOR 6000 BIRD DOG PLUS ONLY
F.1.1 6000 Bird Dog Plus Case
The 6000 Carrying Case has been ergonomically designed to work with the 6000 Bird Dog
Plus. It is an integral part of your new unit. The dimensions are 15.5” x 9.5” x 17.5”. When
you first open the top flap on the carrying case, you will see 3 distinct compartments with
labels. These labels will help you to quickly identify the probe sets or sensors you need.
Everything you will need for low voltage testing of meters and meter circuits is contained in
that carrying case. In addition all the probes are pre-connected to the 6000 Bird Dog Plus, so
connecting and disconnecting the probes and sensors is a thing of the past. Just pull the
connections that you need out of the case, connect them to the site, and put them back in their
appropriate compartment after you are through.
The curved indention on the front panel of the carrying case is there to conveniently
hold your hand in place while you operate the Bird Dog Plus.
The 1
st
compartment is where the 6000 Bird Dog Plus, 3 Phase Connector Box and the
voltage cable are located.
The 2
nd
compartment is where the flexible coil probe, duckbill connectors, and the
small current probes are located.
The 3
rd
or rear compartment is where the following reside:
o Meter sensors
o Large I Probes and/or the High Voltage Probe with Fiber Optic
Cable—Both the Large I Probes and the High Voltage Probe with fiber
optic cable are contained in the same case, when the 1500 High Voltage Kit
is ordered with the 6000 as shown below. When the 1500 High Voltage
Kits is not ordered with the 6000 the Large I Probes are contained in a
separate carrying pouch shown below. Attach both as needed to the 6000
To Next Page
Loading...