SPOT Mayhem 130 - Pivot Bearing Replacement Tools; Tools and Materials for Pivot Bearing Work; Pivot Bearing and O-Ring Specifications

14
Tools Required For Pivot Bearing Replacement:
(In addion to the tools listed above)
• PVC, or other plasc tubes:
27-30mm inner diameter, 45-55mm long
23-25mm inner diameter, 25-30mm long
• An assortment of sockets and extensions for bearing removal, 20-22mm outer diameter
for main pivot bearings, 13-14mm outer diameter for shock yoke pivot bearings
• Several spacers to support the main pivot clevis and upper link for bearing removal and
installaon. These can be made from any hard material, wood, plasc, PVC pipe etc. The
only requirements are that they t into the required openings, are sturdy enough to
support the parts, and are the following widths:
Main Pivot: 62mm (2.44in)
Upper Link Shock Pivot and SS Pivot: 57mm (2.24in)
Upper Link Seat Tube Pivot: 44mm (1.73in)
See pages 35 and 37-38 for illustraons of these spacers’ funcon.
• Arbor press or bench vise for bearing installaon
Pivot Bearing and O-Ring Specicaons:
• Main Pivot Bearings, QTY 2: Enduro 3802 LLU MAX
• Seat Tube Pivot Bearings, QTY 2: Enduro 3802 LLU MAX
• Seat Stay Pivot Bearings, QTY 2: Enduro 3802 LLU MAX
• Shock Yoke Pivot Bearings, QTY 2: Enduro DR 1017 RS MAX
• Main Pivot O-Rings, QTY 4: 1.5 X 18 EPDM
• Seat Tube Pivot O-Rings, QTY 4: 1.5 X 18 EPDM
• Seat Stay Pivot O-Rings, QTY 4: 1.5 X 18 EPDM
• Shock Yoke Pivot O-Rings, QTY 4: 1.5 X 13 EPDM
For individual parts and a complete exploded assembly diagram, please see the last 3 pages
of this manual.