SPOT Mayhem 130 - Rear Triangle Reinstallation; Fitting O-rings and Installing Pivot Axles

48
Rear Triangle Reinstallaon
1. To replace the rear triangle, begin by ng new 1.5 X 18mm inner diameter EPDM o-rings onto the
washers as shown. The easiest way to do this is to lay the washer on a at surface with the at side
down. Then push the o-ring down from the top unl it sits in the installaon groove:
2. Insert the upper pivot axles into the link from the inboard side so that they slightly protrude to the
outboard side. Slide the washers, with o-rings, onto the ends of the axles from the outboard side: