SPOT Mayhem 130 - Internal Dropper Seatpost Routing; Guide Tube Installation and Cable Feed

16
1. Make sure your seatpost collar is installed on the frame. The seatpost cable housing is easiest
to install by feeding from the head tube to the seat tube, but can be fed starng at the seat
tube if necessary. Tape the seatpost cable housing to the guide tube at the head tube end.
Make sure to clean the end of the cable housing and the guide tube with alcohol before
taping. Tape the two together in line, and wrap the tape several mes around the juncon for
sucient contact.
2. While feeding the seatpost cable housing into the frame, gently pull the guide tube out of the
seat tube. If excessive resistance is met, the tape joint may be too bulky and should be
reduced. The cable housing must curve around a relavely small radius between the seat tube
and the down tube.
Internal Dropper Seatpost Roung
IMPORTANT:
Your Mayhem frame is supplied with a guide tube installed in place of the dropper seatpost
cable to ease installaon. Please do not remove the guide tube unl the dropper seatpost cable
is installed.