Need help?Do you have a question about the SPOT Mayhem 130 and is the answer not in the manual?
Covers risks, assembly, scope, and liability for bicycle use.
Details ASTM levels defining safe operating conditions for the bicycle.
Explains adjustment of compression damping for different riding conditions.
Details setting air pressure for sag and ride height, and adjusting for bottoming out.
Describes how volume spacers affect shock progression and bottom-out resistance.
Guide to using the climb/lockout lever for different terrain and preferences.
Instructions for adjusting rebound speed to control suspension return.
How to use the O-ring to measure rear shock travel usage.
Adjusting low-speed compression for support on bermed turns and slow compressions.
Adjusting high-speed compression for square edge hits and landings.
Setting fork air pressure for sag, and adjustments for bottoming out.
How to adjust rebound speed for fork return characteristics.
Using the O-ring to measure fork travel usage.
Explains volume spacers for controlling fork spring force and progression.
Adjusting compression for handling bermed turns and landing jumps.
Setting fork air pressure for sag and ride height, with bottom-out adjustments.
Adjusting rebound speed to control fork return after compression.
How to use the O-ring to measure fork travel.
Details on volume spacers for managing fork progression and bottoming out.
Detailed geometry measurements for the frame in High Mode.
Calculated geometry parameters for different frame sizes.
Instructions for changing frame geometry between High and Low modes.
List of components compatible with the Mayhem 130 frame.
List of tools needed for assembling a frame into a complete bicycle.
Tools required specifically for removing and replacing the rear triangle.
Tools and specific tube sizes required for pivot bearing replacement.
Details on specific bearing and O-ring part numbers and quantities.
Warning against removing or modifying the leaf spring due to potential damage.
Recommendation to check torque on leaf spring mounting fasteners every 100 hours or annually.
Steps for routing the dropper seatpost cable using the provided guide tube.
Installing the rear brake caliper bracket and routing the brake line along the frame.
Routing the derailleur cable housing through the frame from head tube to chainstay.
Observing orientation and torquing bottom bracket cups per manufacturer specs.
Steps for removing and replacing the SRAM UDH derailleur hanger.
Securing the bike and removing the rear wheel and forward shock pivot pin.
Removing the shock and then link axles and O-rings from the rear triangle.
Removing shock yoke axles and O-rings from the link pivot.
Steps for removing main pivot bearings using tools and a workbench setup.
Removing seat tube and shock yoke bearings from the rocker link.
Fitting O-rings to washers and sliding the link assembly onto the seat tube pivot.
Preparing O-rings and inserting upper pivot axles into the link for reinstallation.
Diagram showing all frame components with reference numbers.
Table listing all part numbers, descriptions, and quantities for the frame.
General| Brand | SPOT |
|---|---|
| Model | Mayhem 130 |
| Category | Bicycle Accessories |
| Language | English |
To Next Page