ST STM32F10 Series Application Note

December 2022 AN2586 Rev 8 1/29
1
AN2586
Application note
Getting started with STM32F10xxx hardware development
Introduction
This document is addressed to system designers who need a hardware implementation
overview of the development board features, such as power supply, clock management,
reset control, boot mode settings, and debug management.
It shows how to use the low-density value line, low-density, medium-density value line,
medium-density, high-density, XL-density and connectivity line STM32F10xxx products (the
full list is detailed in Table 1), and describes the minimum hardware resources required to
develop an application. Detailed reference design schematics are also provided, with the
description of the main components, interfaces, and modes.
Table 1. Applicable products
Type Lines
Microcontrollers
STM32F100 Value Line
STM32F101
STM32F102
STM32F103
STM32F105/107
www.st.com

ST STM32F10 Series Specifications

General

Series	STM32F10
Core	ARM Cortex-M3
Operating Frequency	Up to 72 MHz
Flash Memory	16 KB to 1 MB
SRAM	4 KB to 96 KB
GPIO Pins	Up to 80
ADC Resolution	12-bit
Number of ADCs	Up to 3
Operating Voltage	2.0 V to 3.6 V
DAC Resolution	12-bit
Communication Interfaces	I2C, SPI, USART, USB
Operating Temperature	-40°C to +85°C
Package Options	LQFP, BGA
Number of DACs	Up to 2 (some devices)