ST STM32G491 User Manual

RM0440 Rev 4 1073/2126
RM0440 High-resolution timer (HRTIM)
1083
Bits 5:2 FLT5CNT[3:0]: Fault 5 counter
This bitfield selects the FAULT5 counter threshold. A fault is considered valid when the number of
events is equal to the (FLT5CNT[3:0]+1) value.
Bit 1 FLT5BLKS: Fault 5 blanking source
The FTL5BLKS bit selects the FAULT5 blanking source (refer to Table 235 for details).
0: Fault 5 reset-aligned blanking window
1: Fault 5 Moving blanking window
Note: This bitfield is written only when FLT5E enable bit is reset.
Bit 0 FLT5BLKE: Fault 5 blanking enable
The FTL5BLKE bit selects the FAULT5 blanking mode. The blanking source is defined by the
FLT5BLKS bit.
0: No blanking on fault 5
1: Fault 5 blanking mode
Note: This bitfield is written only when FLT5E enable bit is reset

ST STM32G491 Specifications

General

Brand	ST
Model	STM32G491
Category	Microcontrollers
Language	English