6
3 Package content
- Boiler pellet stove model K1700 & K2300
- Side covers, top front cover and bottom front cover
- Instruction Manual &Power cable
3.1 Unpacking the free-standing fire
To unpack the unit, remove the retractable bag containing the cardboard box. Then pull the cardboard box out by lifting it, to
remove the bag containing the unit and the polystyrene plates. To complete the procedure, unscrew the four brackets that secure
the unit to the wood pallet (Error! Reference source not found.).
Figure 1 – Unpacking the unit
4 Safety precautions
Waterford Stanley is not liable for any damages to the stove if the specified precautions, warnings and operating procedures are
not followed.
Waterford Stanley stoves are easy to operate and special attention was given to their components in order to protect users and
installers against accidental damages.
The stoves must only be installed by a qualified installer, who should supply the client with a relevant statement of conformity
and who shall be liable for the final installation and consequent product good operating conditions.
This stove must be used according to its intended use as specified by the manufacturer. The manufacturer is excluded from all
liability, by contract or by tort, caused by injury to people, animals or property arising from misuse or faulty installation or servicing.
After removing the packaging, verify the contents to check their integrity and completeness. If the content of the package
fails to correspond to that indicated in point 1, contact the salesperson from whom you purchased the stove.
All the stove's components guarantee its operation and energy efficiency and should only be replaced with original parts provided
by an authorised technical assistance centre.
The stove must be serviced at least once a year by the installation engineer. This manual is provided with the
product. Please keep it close to the stove.
To Next Page
Loading...
