Stanley QB Expert User Manual

Fastening Cycle Data
QB Expert Alpha Controller
174
If required setup parameters for embedded protocols under Setup>Communications.
8.5 Fastening Cycle Data
Data for each fastening cycle is entered as a line in the fastening cycle record in each controller in the system
for its own spindle. However, when a system is ran in Synchornized mode the fastening cycle records get an
additional column labled Mult ID. This Multi ID is the same in each spindle in the muti-tool system for the same
fastening cycle ran. This allows the user to correlate the same run in each file.

Stanley QB Expert Specifications

General

Brand	Stanley
Model	QB Expert
Category	Controller
Language	English