EasyManuals Logo

Stanley QB Expert User Manual

Stanley QB Expert
214 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #193 background imageLoading...
Page #193 background image
Instruction Manual
185
Maintenance
Fault Possible Cause Probable Solution
Major Consideration
That Led to Solution
To Clear/Reset from
Fault Condition
Temperature Fault!
Wrong value
in Temperature
parameter
Modify
Temperature
parameter value
Viewed
Temperature value
under SETUP->
OTHER-> TOOL tab
and compared with
Temperature value
on ANALYZE screen
Modify
Temperature
parameter value.
The maximum for
handheld tools
is 85˚C. The
maximum for
xtured tools is
125˚C.
Excessive duty cycle
Use a larger tool for
the job
Tool is hot to touch
and shuts down:
QPM tools
shutdown when
tool internal
temperature
reaches and stays
above programmed
set point for 8
minutes
This error
automatically resets
when temperature
drops and stays
below trip point for
8 minutes on QPM
tools.
It can also be reset
by cycling power,
however, if the
tool has not cooled
down this error
will reappear in 8
minutes.
For fixtured tools
turn off Soft Stop.
Inefficient
Rundown Strategy
Contact STANLEY
Assembly
Technologies for
help on modifying
strategy
Tool is hot to touch
and shuts down:
QPM tools
shutdown when
tool internal
temperature
reaches and stays
above programmed
set point for 8
minutes
To prevent an
over temperature,
modify the
strategy by raising
downshift speed
or eliminating the
downshift; Also
try a multi-step
strategy with a
Delay Between
Steps of at least
0.5 seconds.
For fixtured tools
turn off Soft Stop.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Stanley QB Expert and is the answer not in the manual?

Stanley QB Expert Specifications

General IconGeneral
BrandStanley
ModelQB Expert
CategoryController
LanguageEnglish

Related product manuals