– 9 –
3-4. Connecting the Ethernet Cable to the PC
Connect the ethernet cable to a Ethernet port of your router (or hub or switch).
Notes on Using the Auto Cutter
1) To print aer a cut, feed 1 mm (8-dot line) or more of paper.
2) If the cutter is not in its home position aer an error, rst eliminate the cause of the error;
then, turn the power back ON.
3) A margin of 5 mm or more is recommended from the end of the printed area to the cutting
position.
4) Do not attempt to remove the paper during a cut, as this can cause a paper jam.
12) Do not forcibly pull on the interface cable, power cable, or cash drawer cable that is connect-
ed. To detach a connector, make sure to grasp it at the connector portion, without applying
excessive stress on the connector at the printer.
To Next Page
Loading...
