Star Micronics TSP100LAN - 10. Specifications; 10-1. General Specifications

– 27 –
10. Specications
10-1. General Specications
(1) Printing method Direct line thermal printing
(2) Print speed Max. 1000 dots/sec. (125 mm/sec.)
(3) Dot density 203 dpi: 8 dots/mm (0.125 mm/dot)
(4) Printing width Max. 72 mm
(5) Roll paper Refer to chapter 5 for details on the recommended roll paper.
Paper width:79.5±0.5 mm (57.5±0.5 mm when the paper roll
holder is used)
Roll diameter: ø83 mm or less
(6) Overall dimension 142 (W)
× 204 (D) × 132 (H) mm
(7) Weight Auto cutter model : 1.74 kg (without roll paper)
Tear bar model : 1.58 kg (without roll paper)
(8) Noise Approx. 50 dB (Auto cutter model)
50 dB (Tear bar model)
Note: e noise measurements listed above were obtained ac-
cording to conditions established by this company. e
noise measurements may vary depending on the type
of paper used, type of printing and operating environ-
ment.
204 mm
132 mm
142 mm