Star Micronics TSP100LAN - 3-4. Connecting the Ethernet Cable to the PC

– 10 –
3-5. Installing the Printer Soware
Here is the procedure for installing the printer driver and utility soware, which are stored on
the supplied CD-ROM.
e procedure applies to the Windows operating systems shown below.
• Windows 2000
• Windows XP
• Windows Vista 32-Bit
(1) Turn ON the power to your PC to start Windows.
(2) Insert the supplied CD-ROM (Drivers and Utili
-
ties) into the CD-ROM drive.
(3) Follow the instructions that appear on the screen.
(4) e dialog shown in the illustration indicates that
the procedure has been completed.
Click “Finish”.
e dialog that appears on the screen varies with your system.
Continue and register the printer queue, set the port, and perform other settings.
For details, refer to the soware manual.
When using the 64-bit Windows Vista system, install the soware manually. For details on manual
installation, refer to the soware manual in the “Documents” folder on the CD-ROM.
For instructions on the Linux or Macintosh system, refer to the soware manual in the “Linux”
or “Macintosh” folder on the CD-ROM.
Note: Factory-set login password for administrator
TELNET protocol may be used for changing the settings on this printer. To do so, it is
necessary to log in using an administrator account for the printer. Use the following
administrator account information on TELNET.
Administrator account name: “root” (required)
Password: “public” (required)
* e password may be changed aer logging in.
It is recommended to use the Ethernet Setup Tool to change the settings.
For details on the Ethernet Setup Tool, refer to the soware manual.