Star Micronics TSP100LAN - 11. DIP Switch Settings; DIP Switch 1 Settings; Initialize Network Settings Procedure

– 31 –
11. DIP Switch Settings
ere are DIP switches located on the bottom of the printer and various settings can be per-
formed as shown in the following table.
When changing the settings, use the following procedure.
(1) Turn the printer o and disconnect the power cable plug from the AC outlet.
(2) Remove the screw, and then remove the DIP switch cover on the bottom of the printer.
(3) Use a tool with a narrow tip to change the DIP switch settings.
(4) Install the DIP switch cover and secure it with the screw.
Note: e new settings will take eect aer the printer is turned on.
DIP Switch 1
Switch Function ON OFF
1-1 Always ON Should be set to ON
1-2 Always ON Should be set to ON
1-3 Always ON Should be set to ON
1-4 Initializing Settings of the network *1 Invalid Valid
e factory settings of DIP Switch are all on.
1 2 3 4
DIP switch1
ONOFF
*1
Initializing the network settings means deleting the set contents and restoring the network infor-
mation to factory settings. If the printer does not operate properly or if it must be connected to
a dierent circuit, it is recommended to initialize and reset the settings. Beware that initializing
the printer deletes all previous settings, and reverts to factory settings.
Procedure for Initializing the Network Settings
(1) Turn the printer power OFF.
(2) Turn switch 1-4 OFF, and turn the printer power ON.
(3) Aer approximately 15 seconds, turn the printer power OFF.