Star Micronics TSP100LAN - 6-2. Errors (Continued)

– 19 –
3) Paper cut error
Error Description READY Lamp ERROR Lamp Recovery Conditions
Paper cut error O Flashes at
0.125-second
intervals
Recovered by turning the power OFF,
eliminating the cause of the error such as
jammed paper, returning the cutter to its
home position, and turning the power ON
(see 7-3).
Note: If the cutter does not return to its home position or does not perform the initial move-
ment, it will result in a non-recoverable error.
4) Paper detection error
Error Description READY Lamp ERROR Lamp Recovery Conditions
Paper out error Flashes at
0.5-second
intervals
Automatically recovered by loading a new
paper roll, then closing the printer cover.
5) Network errors
Error Description READY Lamp ERROR Lamp Status Recovery Conditions
Network Connec-
tion Normal
On TCP/IP
Communications
Possible
Network Not
Connected
(Physically
Disconnected)
Two ashes
(at 0.125-sec-
ond intervals)
repeated every
two seconds
Physically dis-
connected (e
Ethernet link is
down.)
Check the cable and hub/
router,
then restart the power.
Network Not
Connected (No IP
Address)
Flashes at
0.125-
second inter-
vals
Unable to acquire
an IP address
while DHCP is
active.
Recovered by checking
the wiring circuit and the
DHCP server, and turn-
ing the power back ON (to
dene a temporary IP ad-
dress, use the ARP/Ping).
IP address 0.0.0.0
is assigned while
DHCP is inactive.
Recovered by initializing
the settings at the DIP
switch, and setting the cor-
rect IP address (to dene a
temporary IP address, use
the ARP/Ping).