PREVENTIVE
MAINTENANCE
CHAPTER
5
StarTrac strongly recommends that youperfonnregular preventive maintenance
on
your
§TAR
TRAC
3!100
TREADMILL.
Without regularly scheduled maintenance, nonna1 wear and
tear may cause cumulative effects, such as misalignment or premature wear. Severe breakdown
may result. Therefore, consistently follow the maintenance schedule below. Also, report unusual
symptoms, such as error readings and blown circuit breakers, to Star Trac's Service Hotline at
(800) 503-1221.
NOTE: Turn power "off," and unplug your
§TAR
TRAC
3!100
TREADMILL
from the
wall outlet before performing any
ofthe
following maintenance routrines.
DAILY
MAINTENANCE
• Remove excessive accumulations
of
dust, dirt, and other substances from the Display Control
Panel, handrails, running belt, and motor shroud with a soft, clean cloth and diluted all-purpose
cleaner, such as Fonnu1a 409 or FANTASTIK. Avoid using cleaner under the running belt.
• Inspect the running belt for alignment and tension. Do not tighten it every day
if
it is running
straight and smoothly.
If
you see the belt slipping, adjust its tension using the instructions in
Adjustments-Slipping-Running
Belt, which follow.
• Checkthat the powercord is not damaged and does notrununderneath the treadmill.
If
the cord
appears damaged or altered in any way,
tum
off
treadmill and call for service immediately.
WEEKLY
MAINTENANCE
• Vacuum the floor under and around the treadmill. Do so with the treadmill at its maximum
elevation or moved to another spot.
• Inspect the inside surface
of
the running belt and the top
of
the running deck for unusual wear.
Checkwhether the belt looks glazed and meltedunderneath.
If
you see these signs, flip orreplace
the deck, and/or replace the belt, using the instructions in
Adjustments-Grinding, which follow.
• Check handrail screws for looseness and retighten
if
necessary.
§TAR
TRAC
3!100
TREADMILL
Owner's
Manual
33
To Next Page
Loading...
