5. Repeat steps 2 through 4, on the right side
ofthe
belt/deck.
6.
WALK: Start the treadmill at 1mph and walk on all sections
of
the belt and deck for 1 minute
to ensure
the wax has been evenly distributed and worked-in properly.
7.
CLEANUP: Remove any excess wax with diluted cleaner (409) and towel, or bristle brush.
TIP: Blow away extra wax first (like dust), then wipe.
8.
RESETTING THE MAINTENANCE LED: While the treadmill is on, but not running,
press
the
TIME
display
key,
DISTANCE
display
key, and
the
SPEED
display
key
simultaneously. The MAINTENANCE LED should
tum
"off'.
TI
ME
or
SPLA
Y
KEY
DISTANCE
DISPLAY
KEY
SPEED
DISPLAY
KEY
CALIBRATION
PROCEDURE
Step
1:
Plug
in
and Press Power Switch "ON". Display lights will scroll the "TRACK".
Step
2:
Check to ensure the treadmill is on a flat surface. (Refer to Owner's Manual).
Step
3:
Press "START" for minimum speed. Press
"UP"
to incline to 5% then
"DOWN"
to 0%.
Step
4:
Press
"STOP"
to end. Tum Power Switch off. While depressing "DISPLAY SCROLL",
tum
the Power Switch "ON".
Step
5:
Do
not stand on the belt. Press "START". The treadmill will automatically calibrate at
minimum, 1/2 maximum, & maximum speed for approximately 3 minutes. Aftertreadmill
stops, press "STOP" to end.
If
you are unable to perform any
ofthese
operations, or have any questions about this procedure,
call our customer hotline at 800-503-1221.
§TAR
TRAC
3900
TREADMILL
Owner~!i
Manual
37
To Next Page
Loading...
