To
assemble your
§TAR
TRAC
3900
TREADMILL,
just follow these steps. Note:
Don't
finally tighten the bolts and screws until all the parts are fitted together.
1
Remove
all
the
packaging
material so that the treadmill
is
sitting, ready for assembly, onthe
shipping crate platform. With a
helper, lift the treadmill frame
from the shipping crate platform
and place it in the location where
it will be used. Make sure that it
is
near a power outlet. Caution:
The
motor
shroud
end
of
the
TREADMILL
treadmill is the heavy end, and
may need two people to lift it.
PACKAGING
Remove the holding screw onthe
back center
of
the motor shroud.
Detachthe velcro along the inside
of
each lower side
of
the shroud.
Lift the shroudfrom the treadmill
and place itto the side
ofthe
unit.
RUBBER
GASKET
SHROUD
LEFT
SIDE
HANDRAIL
i!
Locate the front handrail (the one with the display
control panel attached). Do notremove the cable
tie that secures the ribbon cable.
Lower the front handrail legs through the holes
in the top
of
the motor shroud.
§TAR
TRAC
3900
TREADMILL
Owner's
Manual
To Next Page
Loading...
