MAINTENANCE
LED
The
§TAR
TRAC
3900
TREADMILL
is designed with a MAINTENANCE
LED
that
indicates when it is time to rewax the belt and deck
per
the following RE-WAXING procedure.
TREADMILL
RUI\lI\lII\lIi
BELT/DECK
RE-WAXlI\lIi
PROCEDURE:
TOOLS & MATERIALS
1
Bag
Wax Powder, & Teaspoon
1 Clean Towel, & a Paint Stick
or
Ruler
Diluted All-purpose Cleaner (409),
or
Bristle Brush
5/64
Hex
Wrench
PROCEDURE
Apply wax powder while
belt & deck are still warm (5 minutes minimum use) for optimum
benefit.
1.
CLEAN
DECK
& BELT:
A. Using the stick
or
ruler, slide a towel under the
middle
of
the belt from one side
of
the frame to the
other.
B. Hold the edges
of
the towel (treadmill off), pull to
the tailroller, pull to the head-roller, then pull the
beltdown to wipe the remaining belt
= fast & easy.
TIP: Fold the dirty towel & shake into trash.
2.
LIFT
BELT: (See Figure.) Lift the left side (facing
display)
of
the belt, about
12
inches down from the
cover. Hold
the belt up to elevate
half
of
the belt from
the deck.
3.
SPREAD
WAX: (See Figure.) Gently place one level teaspoon
of
wax powder
on
the black
slick-deck
about two inches from the edge, andblow the wax steadily underthe belt. suchthat
the wax powder is evenly distributed across the deck. Extra wax will not harm the treadmill,
but
is unnecessary. TIP: Be neat; minimize cleanup.
4.
Repeat steps 2 & 3, about
18
inches from the end
of
the deck.
36
§TAR
TRAC
3900
TREADMILL
Owner's
Manual
To Next Page
Loading...
