11
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Port Selection Buttons
• Press port selection buttons 3 and 4 simultaneously. The port
selection/link LEDs blink during the Auto Scan process. To
exit the Auto Scan, press any of the port selection buttons.
Hotkeys
If you’re using a computer that’s running a version of Windows
or Linux, you can use hotkey commands to start an Auto Scan.
• Press Left Ctrl, Left Ctrl, F1. The port selection/link LEDs
blink during the Auto Scan process. To exit the Auto Scan,
press Left Ctrl, Left Ctrl. For more information about hotkey
commands, see the “Using hotkey commands” section of the
manual.
Setting Scan Time Duration
You can set the duration of the scan time to 3, 8, 15, or 30
seconds.
Port Selection Button
• Press port selection buttons 1 and 2 simultaneously. The KVM
switch beeps to indicate the duration of the scan time. It will
beep once for 3 seconds, twice for 8 seconds, three times for
15 seconds, and four times for 30 seconds.
Hotkeys
If you’re using a computer that’s running a version of Windows
or Linux, you can use hotkey commands to start an Auto Scan.
To Next Page
Loading...
Need help?
General
