13
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Selecting a Computer
• Press the Left Ctrl key twice and the number of the PC port
that you want to select. For example, if you want to select
computer 2, you would press Left Ctrl, Left Ctrl, 2.
Caution! Don’t use the numeric keyboard on the right side
of your keyboard when you complete the hotkey command
above.
Starting an Auto Scan
• Press Left Ctrl, Left Ctrl, F1. The port selection/link LEDs blink
during the Auto Scan process.
Note: To exit the Auto Scan, press Left Ctrl, Left Ctrl.
Setting Scan Time Duration
You can set the duration of the scan time to 3, 8, 15, or 30
seconds.
• Press Left Ctrl, Left Ctrl, F3. The KVM switch beeps to indicate
the duration of the scan time. It will beep once for 3 seconds,
twice for 8 seconds, three times for 15 seconds, and four times
for 30 seconds.
Scanning Computers Manually
The KVM switch includes a manual scan feature that you can
use to switch between connected computers that are turned
on.
1. Press Left Ctrl, Left Ctrl, F2.
To Next Page
Loading...
Need help?
General
