15
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Using an Alternative hotkey Command
In addition to the Left Ctrl hotkey commands, there are two
alternative commands that you can use to select a computer:
• Press Scroll Lock, Scroll Lock, <the number of the port that
you want to select>.
• Press and hold the Left Shift key and press Num Lock twice.
Release the Left Shift key and then press the number of the
port that you want to select.
Note: Do not use the numeric keypad on the right side of the
keyboard when you complete the hotkey commands listed
above.
About the LED indicators
The KVM switch comes with a port selection/link LED for each
port, as well as a power LED. For more information about the
LEDs, consult the table below.
LED Behavior Scenario
Power LED Illuminated KVM switch is receiving
power
Port
selection/
link LEDs
Illuminated
green
Connected computer is
turned on
Illuminated red Connected computer is
currently selected
Blinking Auto Scan process is in
progress
To Next Page
Loading...
